Tana zaktualizowała swoją Politykę prywatności. Można przeczytać ją tutaj.
Proces recyklinguUdane przedsięwzięciaDouble the amount and resale price of the

Double the amount and resale price of the reusable steel with TANA Shark 440DT

Our customer from southern Europe uses tyre shreds as an alternative heat source instead of coal and oil in a process of making cement out of chalk stone. Formerly they used electric, stationary shredder without an over-band magnet. After changing the machinery to TANA Shark 440DT, the diesel-driven mobile waste shredder on tracks, the customer has been very satisfied on both the improvements in the shredding process and the new profits they have been able to access.

- The cement factory site is a large establishment. Electric shredder used before was required to be installed indoors. The material – end-of-life tyres were transported twice: first into the hall and after shredding, the tyre shreds were transported to the boiler. TANA 440DT being a mobile shredder on tracks, it provides a possibility to shred tyres where the tyre stacks are. Operating process became simpler and both time and money is saved, describes Harri Uusi-Maahi, After Sales Manager from Tana Ltd.

TANA’s over-band magnet doubled the amount of separated steel

Earlier the steel wires from tyres were separated for reuse after the tyre shreds were burned. Both the quality and resale value of a charred steel with burned rubber remains was far from the steel TANA 440DT is able to produce.

- The over-band magnet of the TANA Shark separates the steel wires from the tyre shreds during the shredding process. The separated steel is practically rubber-free and clean. In this case the customer was very surprised that the amount of the resalable steel almost doubled. And so did the resale price.

TANA Shark - Tyres
Steel wires are separated from the tyre shreds during the shredding process by the overband magnet. Bright steel without rubber remains has in average a higher resale price on the market.


Training increases efficiency of operations

Global Tana crew offer s training to operators on how to drive and feed the machine in the most efficient way in different situations. The most common possibilities which might cause maintenance needs are also gone through in order to prevent them. In this case this was done before the machine was shipped.

- By training on using the machine in advance, we can make sure that our customers get all the benefits out of the machinery. It is essential to know for example how driving habits affect to the fuel consumption and what are the best ways to feed the shredder to get optimized lead time, says Uusi-Maahi.

Shredding tyres with TANA Shark

When the machine arrives at the site, Tana crew always runs tests with a number of setups and different particle sizes together with the customers.

The promise of the good service does not end in the implementing phase. The shredder is  connected to internet providing a straight view for authorized persons.

- Therefore, we are always able to help our customers to make better profit from the machinery, to maximise uptime and reacting swiftly to any possible problems or troubleshooting scenarios, concludes Uusi-Maahi.

Our customer said:

”For us TANA Shark represents a new era of shredding tyres”.

See our global sales and services network

TANA Smart Site

TANA Smart Site provides an interface to machine loader/operator on monitoring the output capacities in real-time, which increases production altogether even further.

Tyre particle size

Tana crew tested the shredder on-site with several setups. The best and desired result is achieved with a particle size of 80 mm.

Did you know?

TANA Shark provides the most homogenous particles compared to the other shredders on the market. This is what makes it perfect for tyre shredding for burning purposes. See another case story.


> Open printable PDF


Download a free guide!

Download a free guide

Recycling Processes

  > TANA Products

  > Intelligence

  > Success Stories

  > Brochures

  > Videos